I’m serious when I say that I don’t like to lose.
Since I have been playing this game for a long time now, I have learned how to get creative so I can avoid it too.
That is the little Bench Top hydraulic press I built from scratch a couple of years ago.
It was juuuuust barely tall enough to get the spindle pushed out of the back bearing.
Once I got it out, I flipped the housing over and pressed the back bearing out.
Unfortunately there was no way that I was getting the front bearing off the spindle with it though so a little pondering, a little digging around, some fiddle farting and some determination later,
That’s right bitch, come to Daddy.
I win again.
So now tomorrow, after I get finished having someone scrape and poke around inside my mouth with some sharp metal pointy things, I can get back here and get that housing sanded down, primered and painted.
Then I get to start pondering and fiddle farting again and figure out how I am going to get the new bearings in it.
There is no doubt in my mind that I will figure something out.
Refer to my opening statement.